This section helps troubleshoot common error messages received when E-Z Blaster Web Accelerator tries to connect to the E-Z Blaster service. Click any of the following error messages for resolution information.

Error Messages when Connecting to the E-Z Blaster Service

1. "E-Z Blaster Web Accelerator cannot be started due to an internal error ..."

2. "E-Z Blaster Web Accelerator cannot connect to the E-Z Blaster Service..."

3. "The E-Z Blaster Service does not allow connections from your current IP address..."

4. "Your username and/or password were not accepted by the E-Z Blaster Service..."

5. "The E-Z Blaster Service could not be started due to an authentication timeout ..."

6. "The E-Z Blaster Service indicated that it has insufficient resources to handle your connection..."

---

Error Messages when Connecting to the E-Z Blaster Service

1. "E-Z Blaster Web Accelerator cannot be started due to an internal error ..."

   Try restarting E-Z Blaster Web Accelerator by exiting the program and then re-launching it.

   If the problem persists contact your ISP.

   top

2. "E-Z Blaster Web Accelerator cannot connect to the E-Z Blaster Service..."

   Here is a step-by-step list of things you should verify:

   1. Check that you have successfully connected to your ISP in your usual manner (e.g. Did your dial-up connection successfully connect to your ISP?). This step is independent of whether or not you launch E-Z Blaster Web Accelerator.

   2. Ensure that the ISP you are connected to is, in fact, the one that supplied you with the E-Z Blaster Web Accelerator software and connection information. In most cases, you cannot connect to another ISP and use the same E-Z Blaster Web Accelerator connection settings.

   3. Verify that the Connection information located in the Settings dialog is the same as that provided to you by your ISP.

   4. If you are running firewall software, make sure that a firewall rule is present that allows access to the Remote Server Port (located in the Advanced Connection Settings dialog)

   5. Try uninstalling E-Z Blaster Web Accelerator (ControlPanel-->Add/Remove Programs and select E-Z Blaster Web Accelerator) and then re-install it.

   6. Contact your ISP to verify that the E-Z Blaster Service is up and running.

   Now try restarting E-Z Blaster Web Accelerator by exiting the program and then re-launching it.

   If the problem persists contact your ISP.

   top

3. "The E-Z Blaster Service does not allow connections from your current IP address..."

   The most likely reason you would receive this error is when you connect to the Internet using a different service provider from the one providing you with E-Z Blaster Service. Your ISP may only allow you to use the E-Z Blaster Service when connected to the Internet through them.

   top

4. "Your username and/or password were not accepted by the E-Z Blaster Service..."

   The login credentials you specified on the "Settings" - "Connection" tab were not valid. Your ISP requires you to enter a valid username and password to use the E-Z Blaster Service.

   Click here to view the Product Guide for information on how to set your username and password.

   top

5. "The E-Z Blaster Service could not be started due to an authentication timeout ..."

   Ensure that the authentication information provided to you by your ISP has been keyed in correctly.

   Try reconnecting to your ISP.

   If the problem persists contact your ISP for assistance.

   top

6. "The E-Z Blaster Service indicated that it has insufficient resources to handle your connection..."

   Try reconnecting to your ISP.

   If the problem persists contact your ISP for assistance.

   top